RoboDK Forum> RoboDK (EN)> Request new features> waterjet 3D cutting
RoboDK Forum> RoboDK (EN)> Request new features> waterjet 3D cutting

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
waterjet 3D cutting
Alex Offline
Moderator
*****
Posts: 93
Threads: 0
Joined: Dec 2021
Reputation: 13
#2
03-18-2022, 05:57 PM
There are many ways to do this.

One of them is in your Curve Follow Project, you can add path to tool offset.

Website Find
Reply


Messages In This Thread
waterjet 3D cutting - bygiedrius9999- 03-18-2022, 12:33 PM
RE: waterjet 3D cutting - byAlex- 03-18-2022, 05:57 PM
RE: waterjet 3D cutting - bygiedrius9999- 03-21-2022, 03:59 PM
RE: waterjet 3D cutting - byJeremy- 03-21-2022, 02:23 PM
RE: waterjet 3D cutting - byeduardsik- 03-21-2022, 03:30 PM
RE: waterjet 3D cutting - byJeremy- 03-22-2022, 06:39 PM
RE: waterjet 3D cutting - bygiedrius9999- 03-23-2022, 40点
RE: waterjet 3D cutting - byeduardsik- 03-29-2022, 09:12 PM
RE: waterjet 3D cutting - byJeremy- 03-23-2022, 03:54 PM
RE: waterjet 3D cutting - byJeremy- 03-30-2022, 07:33 PM



Users browsing this thread:
1 Guest(s)

Baidu
map